AURATON 2005 Bedienungsanleitung PDF herunterladen (Seite 3)

INSTALLATION INSTRUCTIONS

Caution: Switch off the electric source before installing the thermostat. We recommend that the installation

should be performed by a trained personnel.

Select a suitable location for the AURATON.

The location of the thermostat can greatly affect

its performance. If it is located at where circulate air

cannot reach, or exposed to direct sun light, it will not

adjust the room temperature properly.

To ensure proper operation, the thermostat should

be installed at an inside wall with freely circulating air.

Find a place where your family usually occupied.

Avoid close to some heat generating appliance

(e.g. TV, heater, refrigerator) or exposed to direct sun

light. Do not install near a door where the thermostat

will suffer from vibration.

Wiring.

Wiring terminals are at the back of the thermostat. Press down the terminal cover, you can find three

terminals which labelled COM, NO and NC. It is a typical single-pole, double throw (SPDT) contact. In most

COM and NO are used.

Mounting the thermostat.

Use the template provided, drill two 6mm holes on the wall. Insert the wall anchors and tighten the left

screw with 3mm clearance. Fix the thermostat by putting it over the screwhead and slide it rightward (note

the keyhole like opening at the back of the thermostat). Tighten the remain screw to lock it in place.

Note:

If the wall is made of wood, there is no need to use the wall anchors. Drill two 2.7mm holes instead of

6mm.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

AURATON 2005 Bedienungsanleitung Seite 3